Wall mounted Plane and Tool Cabinet - Part 16 - Spokeshave rack

Two of my spokeshaves are suitable for hanging using a relatively simple hanging rack.
I made this using some scrap beech. The spokeshaves, a Lie Nielsen Boggs and a Veritas curved sole, were measured and suitable holes bored into each half of the rack. Then the slots were cut on the bandsaw. The LN spokeshave went into place without any more work but the Veritas had to have some carving of the slots done to permit it to go in.

The rack was then mounted on the inside face of the outer door at the top right hand corner

The depth of the slots permits the  shaves to stay in
an upright position.